Hello to all, I'm new to the forum and hoping y'all can help me out.
I have an International 412 Scraper with the transmission with 4 forward and 1 reverse gear, but it is getting no clutch pressure and will not move in any gear. It operated perfectly in all gears up until, while turning ang backing up, the tractor tipped forward and did a nose dive to the dirt. It sat like this for about 5 minutes with the engine idling until I could use our dozer to push on the bowl to put it back upright. I have checked the transmission fluid and the level seemed to be higher up the stick than normal. What could be keeping it from getting clutch pressure? Could there be a valve that got stuck or maybe a vapor lock in one of the lines? If so where would it be and how would i go about fixing it? Any input is GREATLY appreciated! Thanks in advance, Matthew Barnes.
I have an International 412 Scraper with the transmission with 4 forward and 1 reverse gear, but it is getting no clutch pressure and will not move in any gear. It operated perfectly in all gears up until, while turning ang backing up, the tractor tipped forward and did a nose dive to the dirt. It sat like this for about 5 minutes with the engine idling until I could use our dozer to push on the bowl to put it back upright. I have checked the transmission fluid and the level seemed to be higher up the stick than normal. What could be keeping it from getting clutch pressure? Could there be a valve that got stuck or maybe a vapor lock in one of the lines? If so where would it be and how would i go about fixing it? Any input is GREATLY appreciated! Thanks in advance, Matthew Barnes.